Product Series
News
Difference between Molded Hydraulic Seals and Non-molded Turning Seals
Update:2017-02-25
1.Molded Hydraulic Seals:
The filled rubber is heat until melting by molds, thus it has its weaknesses:
(1) Low performance of sealing. The product is defective when the stuffing of the rubber is not enough;
(2) The contraction ratio of the rubber is deviated with the actual product;
(3) Low smoothness of the product;
The raw materials extruded under high-pressure after heated and melted.
Molded Hydraulic Seals and Non-molded Turning Seals from DSH Seals are always with high quality, precisely dimensions, various kinds of materials can meet your specific sealing needs. Contact us now.
Thanks so much for your attention.
The filled rubber is heat until melting by molds, thus it has its weaknesses:
(1) Low performance of sealing. The product is defective when the stuffing of the rubber is not enough;
(2) The contraction ratio of the rubber is deviated with the actual product;
(3) Low smoothness of the product;
(4) Long deliver time as special sizes needing new molds.
The raw materials extruded under high-pressure after heated and melted.
Molded Hydraulic Seals and Non-molded Turning Seals from DSH Seals are always with high quality, precisely dimensions, various kinds of materials can meet your specific sealing needs. Contact us now.
Thanks so much for your attention.